Home / News / How to calculate the efficiency of the reducer

How to calculate the efficiency of the reducer Posted by : admin / Posted on : Aug 08, 2020

When we choose a reducer, we usually observe its quality and performance first, because these two factors affect the efficiency of the equipment. The quality is good, and its performance will be very good. When we use it, the work efficiency is only Will be improved. Therefore, efficiency is an important indicator for testing the working conditions of the equipment, so we can use the following methods to test the working efficiency of our machinery.
1. Generally speaking, the efficiency of the reducer can be determined by theoretical calculations, but due to many influencing factors, certain assumptions need to be made in the quantitative analysis. The theoretical calculation results obtained in this way are only approximate, even if the calculation accuracy can reach ±0.02, and its efficiency value also loses its practical significance. Therefore, the efficiency value of the equipment should be determined through experiments: it is not difficult to test the efficiency of small and medium-sized machinery with a power less than 40kw; for large reducers, test pieces with the same machining accuracy can be designed, and similar lubrication conditions and operating conditions can be selected. A simulation experiment was carried out on special equipment in the laboratory to test the efficiency of the single-stage experimental gearbox, and then the efficiency value was calculated by analogy.
2. For large-scale reducers, we can use test pieces to measure, take similar lubrication conditions and use conditions, conduct simulation experiments on special equipment in the laboratory, test the efficiency of the single-stage experimental gearbox, and then calculate its analogy Efficiency value.
The above methods need to be tested in actual operation. It should be noted that some detailed issues must not be ignored. The so-called details determine success or failure. This is not just talking. Operators should not be careless, otherwise it will easily lead to calculations. Errors occur, and even the reducer can be damaged.

www.reducerfactory.net

0
Views: 801